Georgi's Blog

Add an external voltage regulator to the Eachine Trashcan

April 22, 2019 ⌛ 1 min read
Banggood promo

If you are one of the unlucky folks with a busted 5v regulator on your Eachine Trashcan, fear not. There is a solution and the fix is easier to do than you might expect - add an external 5v regulator.

You can grab a Matek Systems Micro BEC which would get the job done just fine.

Matek Systems package with 3 Micro BEC 6s voltage regulators

Solder a few wires to it. In my case, red silicon wire to the input voltage, black wire to ground and white wire to the 5V output.

Matek voltage regulator with 3 wires soldered to it

Finally, solder the other end of the red wire to your battery positive pad. Solder ground to ground and the white wire to the positive 5V pad, for example where the Trashcan LEDs were connected.

Eachine Trashcan with a micro voltage regulator added

That’s it, enjoy, hopefully, this solves your problems. Do keep in mind that the regulator gets very hot, so mount it away from other components that get hot, such as the vtx, and avoid just keeping the quad plugged in without flying it.

Banggood promo

Did I miss something?

Ask a question and see it updated in the article, alongside with credit for you.


Thanks for your suggestion!

Support the blog:

I hope you find my content helpful. If you'd like to support the blog, you can do so by clicking the affiliate links below before making a purchase. This comes at no additional cost to you.
Or you can buy me a coffee via paypal and support me on Patreon.
Links to Banggood or Amazon in this article are affiliate links and would support the blog if used to make a purchase.

📰 Monthly Newsletter

Get the latest scoop of what's new in the FPV drone racing and freestyle world. What to watch, who to follow and more.

I hate spam, and so I don't spam. Unsubscribe at any time.

Need even more FPV in your life? Check out my YouTube channels:

Banggood promo